#include <Wire.h>
#include "DHTesp.h"
const int DHT_PIN=12;
DHTesp dhtSensor;
#include <Adafruit_GFX.h>
#include <Adafruit_SSD1306.h>
 
#define SCREEN_WIDTH 128 // OLED display width, in pixels
#define SCREEN_HEIGHT 64 // OLED display height, in pixels
 
// Declaration for an SSD1306 display connected to I2C (SDA, SCL pins)
#define OLED_RESET     4 // Reset pin # (or -1 if sharing Arduino reset pin)
Adafruit_SSD1306 display(SCREEN_WIDTH, SCREEN_HEIGHT, &Wire, OLED_RESET);
 
#define NUMFLAKES     10 // Number of snowflakes in the animation example
#define LOGO_HEIGHT   16
#define LOGO_WIDTH    16
static const unsigned char PROGMEM logo_bmp[] =
{ B00000000, B11000000,
  B00000001, B11000000,
  B00000001, B11000000,
  B00000011, B11100000,
  B11110011, B11100000,
  B11111110, B11111000,
  B01111110, B11111111,
  B00110011, B10011111,
  B00011111, B11111100,
  B00001101, B01110000,
  B00011011, B10100000,
  B00111111, B11100000,
  B00111111, B11110000,
  B01111100, B11110000,
  B01110000, B01110000,
  B00000000, B00110000 };
void setup() {
  // put your setup code here, to run once:
  Serial.begin(115200);
  dhtSensor.setup(DHT_PIN,DHTesp::DHT22);
  if(!display.begin(SSD1306_SWITCHCAPVCC, 0x3c)) { // Address 0x3c for 128x64
    Serial.println(F("SSD1306 allocation failed"));
    for(;;); // Don't proceed, loop forever
  }
  dhtSensor.setup(DHT_PIN,DHTesp::DHT22);
}

void loop() {
  TempAndHumidity data = dhtSensor.getTempAndHumidity();
  Serial.println("Temp: " + String(data.temperature, 2)+"C");
  Serial.println("Humidity: " + String(data.humidity, 1)+"%");
  Serial.println("---");
  display.clearDisplay();
  display.setTextColor(1);
  display.setTextSize(1);
  display.setCursor(0,10);
  Serial.print("Temp: ");
  Serial.print(String(data.temperature, 2));
  Serial.print("C");

  display.setCursor(0,20);
  Serial.print("Humidity");
  Serial.print(String(data.humidity, 2));
  Serial.print("%");
  display.display();
  delay(2000); // this speeds up the simulation

  
}