// Make sure to include Onewire and Dallas Temperature libraries
#include <OneWire.h>
#include <DallasTemperature.h>
 
// Connect your yellow pin to Pin12 on Arduino
#define ONE_WIRE_BUS 12
 
// Setup a oneWire instance to communicate with any OneWire devices
OneWire oneWire(ONE_WIRE_BUS);
 
// Pass our oneWire reference to Dallas Temperature sensor 
DallasTemperature sensors(&oneWire);

float tempCL = 0;
float tempFH = 0;

 



 
void setup()
{
  // initialize the Serial Monitor at a baud rate of 9600.
  Serial.begin(9600);
  
  sensors.begin();
}
 
void loop(){ 
 sensors.requestTemperatures(); // Call sensors.requestTemperatures() to issue a global temperature and Requests to all devices on the bus
  
  tempCL=sensors.getTempCByIndex(0);
 tempFH=sensors.getTempFByIndex(0);

 
  Serial.print("Celsius temperature: ");
  Serial.print(tempCL); 
  Serial.print(" - Fahrenheit temperature: ");
  Serial.println(tempFH);
  delay(1000);
}