//! Blinks an LED
//!
//! This assumes that a LED is connected to the pin assigned to `led`. (GPIO4)

#![no_std]
#![no_main]

use esp_backtrace as _;
use esp_println::println;
use hal::{
    clock::ClockControl, gpio::IO, peripherals::Peripherals, prelude::*, timer::TimerGroup, Delay,
    Rtc,
};

#[entry]
fn main() -> ! {
    let peripherals = Peripherals::take();
    let mut system = peripherals.DPORT.split();
    let clocks = ClockControl::boot_defaults(system.clock_control).freeze();

    let timer_group0 = TimerGroup::new(
        peripherals.TIMG0,
        &clocks,
        &mut system.peripheral_clock_control,
    );
    let mut wdt = timer_group0.wdt;
    let mut rtc = Rtc::new(peripherals.RTC_CNTL);

    // Disable MWDT and RWDT (Watchdog) flash boot protection
    wdt.disable();
    rtc.rwdt.disable();

    // Set GPIO4 as an output, and set its state high initially.
    let io = IO::new(peripherals.GPIO, peripherals.IO_MUX);
    let mut led = io.pins.gpio4.into_push_pull_output();

    led.set_high().unwrap();

    // Initialize the Delay peripheral, and use it to toggle the LED state in a
    // loop.
    let mut delay = Delay::new(&clocks);
    println!("Hello world!");
    loop {
        delay.delay_ms(1000u32);
        led.toggle().unwrap();
    }
}