joy_waldon2003's projects

An Arduino program to Change the Blinking speed of led using the "POTENTIOMETER".
about 1 year ago
10. B2 Serial Print “ Hello World “ ?
about 1 year ago
add sub Copy
about 1 year ago
Write a program in Arduino UNO , Enter Password is Wrong or Right by using Red and Green LED.
about 1 year ago
Q9. // “LDR Sensor” With LED Bulb & Also With “Serial Monitor” and “LCD Screen” ?
about 1 year ago
Q7. // Pattern In LED {ON ON ON} , {ON OFF ON} , {OFF ON OFF}.
about 1 year ago
Q3. Fade : This Example shows how to fade an LED on Pin9 using.
about 1 year ago
Q1. Turn An Led On for one point five second, Then off for three mini second, Repeatedly.
about 1 year ago
Write a Arduino program to interface the HC-SR04 ultrasonic sensor, an LED at pin 10, and a buzzer at pin 11. If the distance is less than 15 cm, the LED and buzzer will blink. The measured distance will be displayed on the Serial Monitor.
about 1 year ago
Write an Arduino program that performs basic arithmetic operations ( + , - , / , * ) between two integers and prints the result using the Serial Monitor.
about 1 year ago
Write a Arduino program to control multiple LEDs using an array for pin assignments.
about 1 year ago
While.LOOP .Write a Arduino program to print numbers from 0 to 10 using a while loop and display each count on the Serial Monitor?
about 1 year ago
Buzzer Lighting
about 1 year ago
LDR Alarm Activation
about 1 year ago
mega-7219-matrix-tunnel
about 1 year ago
Chrome DIno
about 1 year ago
scintillating_heatshrink
about 1 year ago
KEYPAD CALCULATOR
about 1 year ago
Blinking LED by FOR loop
about 1 year ago
Relay Sensor Value
about 1 year ago
LM35 Sensor With LCD Display.
about 1 year ago
//Write a Program to Interface any Analog (Pollution) sensor and display the value read on serial monitor.
about 1 year ago
Ultrasonic Distance Sensor only
about 1 year ago
Write a program in Arduino UNO , To Interface an LED with IR sensor.
about 1 year ago
Q4.Using an Arduino UNO and a Buzzer connected to Pin9, Write a program to toggle the Buzzer ON and OFF every second. Additionally, print "Buzzer ON for 500sec" and "Buzzer OFF for 500sec" to the Serial Monitor with each toggle.
about 1 year ago
16. B11 Interface LCD and KEYPAD with Arduino Uno Board and Display the key pressed from the KEYPAD on LCD ?
about 1 year ago
// PUSH BUTTON!
about 1 year ago
Servo and Ldr
about 1 year ago
Q5.The code displays "I.O.T" on the first line and continuously displays the current milliseconds on the third line of a 20x4 LCD screen connected via I2C.
about 1 year ago
PIR Motion Sensor (Passive Infrared Sensor)
about 1 year ago
Servo Motor 2
about 1 year ago
RGB LED Light
about 1 year ago