int analogPin = 3;
int analogPin1 =4;
const int SwPin =  11; 
const int ledPin =  13; 
const int ledPin2 =  12;     // potentiometer wiper (middle terminal) connected to analog pin 3

                       // outside leads to ground and +5V

int val = 0;           // variable to store the value read
int val1 = 0;
int ledState = LOW; 

unsigned long previousMillis = 0; 
int long interval = 1000;  

void setup()

{

  Serial.begin(9600);          
  pinMode(ledPin, OUTPUT);
  pinMode(ledPin2, OUTPUT);
  pinMode(SwPin, OUTPUT);

digitalWrite(SwPin, HIGH);
      digitalWrite(ledPin, HIGH);
delay(1000);
      val1 = analogRead(analogPin1);
      Serial.println(val1);

      if (val1 > 1000) {
       digitalWrite(ledPin2, HIGH);
    }

      delay(1000);
       digitalWrite(ledPin, LOW);
       
  
         val1 = analogRead(analogPin1);
 Serial.println(val1);

  delay(500);
digitalWrite(SwPin, LOW);

}



void loop()

{

/*
   unsigned long currentMillis = millis();

  if (currentMillis - previousMillis >= interval) {
   
    previousMillis = currentMillis;

    // if the LED is off turn it on and vice-versa:
    if (ledState == LOW) {
      ledState = HIGH;
    } else {
      ledState = LOW;
    }

    digitalWrite(ledPin, ledState);
    interval=interval-50;
   
  }

  val = analogRead(analogPin);    // read the input pin
 //val1 = analogRead(analogPin1);
  Serial.println(val);       
 //  Serial.println(val1);        // debug value
//  Serial.println(ledState); 
*/
}