#if defined(ESP8266)
#include <ESP8266WiFi.h>
#elif defined(ESP32)
#include <WiFi.h>
#endif

#define WIFI_SSID "Wokwi-GUEST"
#define WIFI_PASSWORD ""

#define SERIAL_DEBUG_BAUD 115200

#define LED 15
#define BUTTON 21
int myLed[5] = {15, 14, 13, 12, 27};
int status = WL_IDLE_STATUS;

void InitWiFi(){
  Serial.println("Connecting to AP...");

  WiFi.begin(WIFI_SSID, WIFI_PASSWORD);
  while (WiFi.status() != WL_CONNECTED){
    delay(500);
    Serial.print(".");
  }
  Serial.println("Connected to AP");
}

void reconnect(){
  status = WiFi.status();
  if(status != WL_CONNECTED){
    WiFi.begin(WIFI_SSID,WIFI_PASSWORD);
    while (WiFi.status() != WL_CONNECTED){
      delay(500);
      Serial.print(".");
    }
    Serial.println("Connected to AP");
  }
}

void setup() {
  // put your setup code here, to run once:
  Serial.begin(SERIAL_DEBUG_BAUD);
  Serial.println("");
  // InitWiFi();
  for(int i=0;i<=5;i++){
    pinMode(myLed[i], OUTPUT);
  }
  pinMode(BUTTON, INPUT);
}

void loop() {
  // put your main code here, to run repeatedly:
  // delay(1000); // this speeds up the simulation
  if(digitalRead(BUTTON)== HIGH){
    if(WiFi.status() != WL_CONNECTED){
      reconnect();
    }
    Serial.print(F("Wifi terkoneksi dengan"));
    Serial.println(WIFI_SSID);
    Serial.print("IP: ");
    Serial.println(WiFi.localIP());
    for(int i=0;i<=5;i++){
      digitalWrite(myLed[i], HIGH);
      delay(1000);
      digitalWrite(myLed[i], LOW);      
    }

    for(int i=5;i>=0;i--){
      digitalWrite(myLed[i], HIGH);
      delay(1000);
      digitalWrite(myLed[i], LOW);      
    }
  }
  
}