#include <Servo.h>
#include "DHT.h"
#define DHTPIN 2    
#define DHTTYPE DHT22 
DHT dht(DHTPIN, DHTTYPE);
#define lampum 1
#define lampuk 2
#define lampuh 3
#define alarm 4
Servo myservo1;
Servo myservo2;


void setup() {
  // put your setup code here, to run once:
pinMode(lampum, OUTPUT);
pinMode(lampuk, OUTPUT);
pinMode(lampuh, OUTPUT);
myservo1.attach(5);
myservo2.attach(6);
pinMode(alarm, OUTPUT);
Serial.begin(9600);
  Serial.println("Sensor Suhu dan Kelembapan");
  dht.begin();

}

void loop() {
  // put your main code here, to run repeatedly:
 // Wait a few seconds between measurements.
  delay(2000);

  // Reading temperature or humidity takes about 250 milliseconds!
  // Sensor readings may also be up to 2 seconds 'old' (its a very slow sensor)
  float humidity = dht.readHumidity();
  // Read temperature as Celsius (the default)
  float temperature = dht.readTemperature();

  // Check if any reads failed and exit early (to try again).
  if (isnan(humidity) || isnan(temperature)) {
    Serial.println("Sensor Gagal Berfungsi");
    return;
  }
  Serial.print("Humidity: ");
  Serial.print(humidity);
  Serial.print("%");
  Serial.print(" Temperature: ");
  Serial.print(temperature);
  Serial.print("°C");
  Serial.println();

  //kondisi1
  if(humidity <30 && temperature >80){
    Serial.print("kondisi kelembapan normal");
    Serial.println();
    digitalWrite(lampum, LOW);
    digitalWrite(lampuk, LOW);
    digitalWrite(lampuh, HIGH);
    
    ;
  }
}
}