#include "DHT.h"

#define DHTPIN 2     
#define DHTTYPE DHT22   // DHT 22  (AM2302), AM2321

DHT dht(DHTPIN, DHTTYPE);
int led=8;
int led1=7;

void setup() {
  // put your setup code here, to run once:
 pinMode(led, OUTPUT);
 pinMode(led1, OUTPUT);
 Serial.begin(115200);
 Serial.println(F("DHT22 example!"));

  dht.begin();
}

void loop() {
  // put your main code here, to run repeatedly:
   float temperature = dht.readTemperature();
   float humidity = dht.readHumidity();
   if (temperature<=35){
   digitalWrite(led, HIGH);
   digitalWrite(led1, LOW);
   }
   else{
   digitalWrite(led1, HIGH);
   digitalWrite(led, LOW);
   }
   

    // Check if any reads failed and exit early (to try again).
  if (isnan(temperature) || isnan(humidity)) {
    Serial.println(F("Failed to read from DHT sensor!"));
    return;
  }
  Serial.print(F("Humidity: "));
  Serial.print(humidity);
  Serial.print(F("%  Temperature: "));
  Serial.print(temperature);
  Serial.println(F("°C "));

  // Wait a few seconds between measurements.
  delay(1000);

}