#include <Servo.h>

int servoPin = 3;
Servo servo;
int angle = 0;  // servo position in degrees

int pin_4 = 4;
int pin_5 = 5;
int pin_3 = 3;
int SPEAKER = 10;    // The speaker is on pin 8
int freq = 10;  

void setup() {
  // put your setup code here, to run once:
  pinMode(pin_4, OUTPUT);
  pinMode(pin_5, OUTPUT);
  servo.attach(servoPin);
  pinMode(SPEAKER, OUTPUT);

}


void loop() {
  // for(angle = 0; angle < 180; angle++) {
  //     servo.write(angle);
  //     delay(15);
  // }
   
  tone(SPEAKER, freq);
  servo.write(0);
  digitalWrite(pin_4, HIGH);
  delay(1000);  
  Serial.print("Key Pressed : ", digitalRead(pin_4));
  
  servo.write(90);
  digitalWrite(pin_4, LOW);
  noTone(SPEAKER);
  delay(1000);

  


}