//Complete Guide to Arduino
//Created by Zaqyas Mahmood, InnoVech
//Lesson 6 While and For Loops

/////// Constant Variables Intialised ///////
const int LED1 = 13;
const int LED2 = 12;
const int LED3 = 11;
const int LED4 = 10;
const int LED5 = 9;
const int LED6 = 8;

////// Changeable Variables Intialised ///////
int Count = 0;
int Count2 = 0;


void setup() 
{
 pinMode(LED1, OUTPUT);
 pinMode(LED2, OUTPUT);
 pinMode(LED3, OUTPUT);
 pinMode(LED4, OUTPUT); 
 pinMode(LED5, OUTPUT);
 pinMode(LED6, OUTPUT);
 digitalWrite(LED1,LOW);
 digitalWrite(LED2,LOW);
 digitalWrite(LED3,LOW);
 digitalWrite(LED4,LOW); 
 digitalWrite(LED5,LOW);
 digitalWrite(LED6,LOW);  
}

void loop() 
{
// Slider();
/*  digitalWrite(LED1, LOW);  //Turn off LED1 on MFS
  digitalWrite(LED2, LOW); //Turn off LED2 on MFS
  digitalWrite(LED3, LOW);  //Turn off LED1 on MFS
  digitalWrite(LED4, LOW); //Turn off LED2 on MFS
  digitalWrite(LED5, LOW);  //Turn off LED1 on MFS
  digitalWrite(LED6, LOW); //Turn off LED2 on MFS*/   

  //The while condition true until Count is less than 10
  while (Count <= 0)
  { 
    digitalWrite(LED1, HIGH);
    digitalWrite(LED3, HIGH);
    delay(3000);  
    digitalWrite(LED1, LOW);
    digitalWrite(LED3, LOW); 
    delay(3000);

    digitalWrite(LED1, HIGH);
    digitalWrite(LED1, HIGH);
    digitalWrite(LED3, HIGH);
    digitalWrite(LED3, HIGH);
    digitalWrite(LED5, HIGH);
    digitalWrite(LED5, HIGH);
    delay(3000); 

    digitalWrite(LED1, LOW);
    digitalWrite(LED1, LOW);
    digitalWrite(LED3, LOW);
    digitalWrite(LED3, LOW);
    digitalWrite(LED5, LOW);
    digitalWrite(LED5, LOW);
    delay(1500);    
  
   for (int i = 0; i <= 255; i++) 
   digitalWrite(LED1,HIGH);
   Serial.print(i);
   delay(10);


    Count++;
  }
  digitalWrite(LED1, LOW); //Once Count is equal to 10 turn LED off


  //The For loop initialises Count2
  //The Condition is true until Count2 is less than or equal to 25
  for (Count2; Count2 <= 5; Count2++);
  {
  

    digitalWrite(LED2, HIGH);
    delay(500);
    digitalWrite(LED2, LOW);
    delay(500);
  }
   digitalWrite(LED2, LOW); //When Count2 is equal to 25 turn LED2 off
}


/*
void Slider() {
  // read the input on analog pin 0:
  int sensorValue = analogRead(A0);
  // print out the value you read:
  Serial.println(sensorValue);
  delay(1);        // delay in between reads for stability
}*/