/**
   ESP32 + DHT22 Example for Wokwi
   
   https://wokwi.com/arduino/projects/322410731508073042
*/
// Simple demonstration on using an input device to trigger changes on your
// NeoPixels. Wire a momentary push button to connect from ground to a
// digital IO pin. When the button is pressed it will change to a new pixel
// animation. Initial state has all pixels off -- press the button once to
// start the first animation. As written, the button does not interrupt an
// animation in-progress, it works only when idle.

#include <Adafruit_NeoPixel.h>
#include "DHT.h"

#ifdef __AVR__
 #include <avr/power.h> // Required for 16 MHz Adafruit Trinket
#endif

// Digital IO pin connected to the button. This will be driven with a
// pull-up resistor so the switch pulls the pin to ground momentarily.
// On a high -> low transition the button press logic will execute.


#define PIXEL_PIN    2  // Digital IO pin connected to the NeoPixels.
#define PIXEL_COUNT 30  // Number of NeoPixels
const int DHT_PIN = 15;

DHT dhtSensor;

void setup() {
  Serial.begin(115200);
  dhtSensor.setup(DHT_PIN, DHT::DHT22);
}

void loop() {
  TempAndHumidity  data = dhtSensor.getTempAndHumidity();
  Serial.println("Temp: " + String(data.temperature, 2) + "°C");
  Serial.println("Humidity: " + String(data.humidity, 1) + "%");
  Serial.println("---");
  delay(1000);
}