#include <IRremote.h>
#define PIN_RECEIVER 2   // Signal Pin of IR receiver

IRrecv receiver(PIN_RECEIVER);

int led = 5;

void setup()
{
  Serial.begin(9600);
  pinMode (led, OUTPUT);
  receiver.enableIRIn(); // Start the receiver
}

void loop()
{
  // Checks received an IR signal
  if (receiver.decode()) {
    translateIR();
    receiver.resume();  // Receive the next value
  }
}



void translateIR()
{
  // Takes command based on IR code received
  switch (receiver.decodedIRData.command) {
    case 162:
      Serial.println("POWER");
      digitalWrite(led, HIGH);
      break;
    case 226:
      Serial.println("MENU");
      break;
    case 34:
      Serial.println("TEST");
      break;
    case 2:
      Serial.println("PLUS");
      break;
    case 194:
      Serial.println("BACK");
      break;
    case 224:
      Serial.println("PREV.");
      break;
    case 168:
      Serial.println("PLAY");
      break;
    case 144:
      Serial.println("NEXT");
      break;
    case 104:
      Serial.println("num: 0");
      break;
    case 152:
      Serial.println("MINUS");
      break;
    case 176:
      Serial.println("key: C");
      break;
    case 48:
      Serial.println("num: 1");
      break;
    case 24:
      Serial.println("num: 2");
      break;
    case 122:
      Serial.println("num: 3");
      break;
    case 16:
      Serial.println("num: 4");
      break;
    case 56:
      Serial.println("num: 5");
      break;
    case 90:
     
      break;
    case 66:
      
      break;
    case 74:
      
      break;
    case 82:
      
      break;
    default:
      
      Serial.println();
      
  }
}