int q_pins[] = {6, 7, 8, 9 , 10 , 11 , 12, 13};

#define ENABLE 5 // Enable pin
#define DS     2 // Serial Data
#define STCP   3 // Serial Clock
#define SHCP   4 // Storage Latch

int8_t get_memory(uint16_t address) {

  // Set the address to be accessed, into
  // the shift register
  uint8_t low = address & 0xff;
  uint8_t high = (address >> 8);
  digitalWrite(SHCP, LOW);
  shiftOut(DS, STCP, MSBFIRST, high);
  shiftOut(DS, STCP, MSBFIRST, low);
  digitalWrite(SHCP, HIGH);

  // Set the chip enable to low, and read
  // the data lines, and then set the chip
  // enable high again
  digitalWrite(ENABLE, LOW);
  uint8_t byte = 0;
  for (int i = 0; i < 8; i++) {
    uint8_t bit = digitalRead(q_pins[i]);
    if (bit == HIGH) {
      byte = (byte >> 1) | 0x80;
    }
    else {
      byte = byte >> 1;
    }
  }
  digitalWrite(ENABLE, HIGH);

  // Return the byte
  return byte;
}

void setup() {
  // put your setup code here, to run once:
  Serial.begin(115200);

  pinMode(DS, OUTPUT);     // Serial data pin
  pinMode(ENABLE, OUTPUT); // Chip enable pin
  pinMode(STCP, OUTPUT);   // Shift register clock
  pinMode(SHCP, OUTPUT);   // Shift register output latch

  // Set enable to high, so no chip is selected
  digitalWrite(ENABLE, HIGH);

  // Set the data lines to input
  for (int i = 0; i < 8; i++) {
    pinMode(q_pins[i], INPUT);
  }

  uint8_t byte = 0;

  // Read the first 32 bytes from the first chip
  Serial.println("Dump data of 64 bytes from the first EPROM chip.");
  for (int i = 0; i < 64; i++) {
    byte = get_memory(i);
    Serial.print("Memory: ");
    Serial.print(i);
    Serial.print(" - Byte: ");
    Serial.println(byte);
  }

  // Read the first 32 bytes from the second chip
  Serial.println("Dump data of 64 bytes from the second EPROM chip.");
  for (int i = 0; i < 64; i++) {
    byte = get_memory(i+2048);
    Serial.print("Memory: ");
    Serial.print(i+2048);
    Serial.print(" - Byte: ");
    Serial.println(byte);
  }

  // Dump string from the first EPROM chip
  unsigned long pos = 0;
  while ((byte = get_memory(pos)) != 0) {
    Serial.print((char)byte);
    pos++;
  }
  Serial.println("");

  // Dump string from the second EPROM chip
  pos = 2048;
  while ((byte = get_memory(pos)) != 0) {
    Serial.print((char)byte);
    pos++;
  }
  Serial.println("");

}

void loop() {
  // put your main code here, to run repeatedly:
  delay(10); // this speeds up the simulation
}