#ifdef ARDUINO_ARCH_ESP32
#include <WiFi.h>
#else
#include <ESP8266WiFi.h>
#endif
#include <ESP32Servo.h>

const char* ssid = "THUB";
const char* password = "Emprender1";

Servo lock;
const int rele = 2;
const int pin_lock = 4;

const int Led = 23;

void setup() {
  // put your setup code here, to run once:
  Serial.begin(115200);
  Serial.println("Hola p!");
  pinMode(rele,OUTPUT);
  pinMode(Led, OUTPUT);
  lock.attach(pin_lock);
  ConectarWifi();
}

void loop() {
  // put your main code here, to run repeatedly:
  digitalWrite(rele, HIGH);
  lock.write(90);
  delay(1000);
  lock.write(0);
  delay(1000);
  delay(100);
  digitalWrite(rele, LOW);
  delay(100);
  delay(10); // this speeds up the simulation
}

void ConectarWifi() {
  if (WiFi.status() != WL_CONNECTED) {
    WiFi.mode(WIFI_STA);
    WiFi.begin(ssid, password);
    Serial.println("");
    Serial.println("Conectando WiFi");
    while (WiFi.status() != WL_CONNECTED) {
      digitalWrite(Led, 1);
      delay(500);
      digitalWrite(Led, 1);
      delay(500);
      Serial.print(".");
    }
    Serial.print("Conectando a ");
    Serial.println(ssid);
    Serial.print("IP: ");
    Serial.println(WiFi.localIP());
  }
}