int switch1=34;
int switch2=32;
int switch3=33;

void setup() {
  // put your setup code here, to run once:
  Serial.begin(115200);
  //Serial.println("Hello, ESP32!");
  pinMode(13, OUTPUT);
  pinMode(12, OUTPUT);
  pinMode(14, OUTPUT);
  pinMode(27, OUTPUT);
  pinMode(26, OUTPUT);
  pinMode(25, OUTPUT);
  pinMode(34,INPUT);
  pinMode(32,INPUT);
  pinMode(33,INPUT);
}

void loop() {
  // put your main code here, to run repeatedly:
  // Leftside red and rightside green will glow and other LED will off
  switch1=digitalRead(34);
  if(switch1==1)
  {
  digitalWrite(13, HIGH);
  digitalWrite(25, HIGH);
  }
  else
  {
  digitalWrite(13, LOW);
  digitalWrite(25, LOW);
  }
  switch2=digitalRead(32);
  if(switch2==1){
  // this speeds up the simulation
  // Bothside will glow and remaining will off
  digitalWrite(26, HIGH);
  digitalWrite(12, HIGH);
  }
  else
  {
  digitalWrite(26, LOW);
  digitalWrite(12, LOW);
  }
  switch3=digitalRead(33);
  if(switch3==1){
  digitalWrite(14, HIGH);
  digitalWrite(27, HIGH);
  }
  else{
  digitalWrite(14, LOW);
  digitalWrite(27, LOW);
  }
  /*digitalWrite(25, HIGH);
  digitalWrite(13, HIGH);
  digitalWrite(26, LOW);
  digitalWrite(12, LOW);
  digitalWrite(14, LOW);
  digitalWrite(27, LOW);
  delay(1000);*/
}