#include "millisDelay.h"
int led1 = 2;
int led2 = 3;
int led3 = 13;
// Pin 13 has an LED connected on most Arduino boards.
bool led1On = false; // keep track of the led state
bool led2On = false; // keep track of the led state
millisDelay led_1_Delay;
millisDelay led_2_Delay;
millisDelay led_3_Delay;
void setup()
{
  // initialize the digital pin as an output.
  pinMode(led1, OUTPUT);   // initialize the digital pin as an output.
  pinMode(led2, OUTPUT);   // initialize the digital pin as an output.
  pinMode(led3, OUTPUT);   // initialize the digital pin as an output.
  pinMode(19, INPUT_PULLUP);   // initialize the digital pin as an output.

  // start delay
  led_1_Delay.start(700);
  led_2_Delay.start(1000);
}
void loop()
{
  // check if delay has timed out
  if (led_1_Delay.justFinished())
  {
    led_1_Delay.repeat(); // start delay again without drift
    // toggle the led
    led1On = !led1On;
    digitalWrite(led1, led1On);

  }

  if (led_2_Delay.justFinished())
  {
    led_2_Delay.repeat(); // start delay again without drift
    // toggle the led
    led2On = !led2On;
    digitalWrite(led2, led2On);

  }

  if (  led_3_Delay.justFinished()  ) digitalWrite(13, LOW);

  if ( !led_3_Delay.isRunning())
  {
    if (digitalRead(19) == LOW)
    {
      led_3_Delay.start(2000);
      digitalWrite(13, HIGH);
    }
  }




}