#include <LiquidCrystal.h>
// Create An LCD Object. Signals: [ RS, EN, D4, D5, D6, D7 ]
LiquidCrystal My_LCD(13, 12, 14, 27, 26, 25);

#include "DHT.h"

#define DHTPIN 4     // Digital pin connected to the DHT sensor
// Feather HUZZAH ESP8266 note: use pins 3, 4, 5, 12, 13 or 14 --
// Pin 15 can work but DHT must be disconnected during program upload.

// Uncomment whatever type you're using!
//#define DHTTYPE DHT11   // DHT 11
#define DHTTYPE DHT22   // DHT 22  (AM2302), AM2321
//#define DHTTYPE DHT21   // DHT 21 (AM2301)

// Connect pin 1 (on the left) of the sensor to +5V
// NOTE: If using a board with 3.3V logic like an Arduino Due connect pin 1
// to 3.3V instead of 5V!
// Connect pin 2 of the sensor to whatever your DHTPIN is
// Connect pin 4 (on the right) of the sensor to GROUND
// Connect a 10K resistor from pin 2 (data) to pin 1 (power) of the sensor

// Initialize DHT sensor.
// Note that older versions of this library took an optional third parameter to
// tweak the timings for faster processors.  This parameter is no longer needed
// as the current DHT reading algorithm adjusts itself to work on faster procs.
DHT dht(DHTPIN, DHTTYPE);



void setup() {
  dht.begin();
  Serial.begin(9600);
 // Initialize The LCD. Parameters: [ Columns, Rows ]
  My_LCD.begin(16, 2);
  // Clears The LCD Display
  My_LCD.clear();

  My_LCD.print("Temp:");
  
  // Set The Cursor Position To: [ Col 5, Row 1]
  // The Next Message Will Start From The 6th Char Position in The 2nd Row
  // Note: 1st Row Has An Index of 0, The 2nd Row Has An Index of 1
  My_LCD.setCursor(0, 1);
  // Display The Second Message In Position (5, 1)
  My_LCD.print("RH  :");
  
}

int count;
double num;
void loop() {
  
  delay(2000);

  // Reading temperature or humidity takes about 250 milliseconds!
  // Sensor readings may also be up to 2 seconds 'old' (its a very slow sensor)
  float h = dht.readHumidity();
  // Read temperature as Celsius (the default)
  float t = dht.readTemperature();
  // Read temperature as Fahrenheit (isFahrenheit = true)
  float f = dht.readTemperature(true);

  // Check if any reads failed and exit early (to try again).
  if (isnan(h) || isnan(t) || isnan(f)) {
    Serial.println(F("Failed to read from DHT sensor!"));
    return;
  }
  My_LCD.setCursor(5, 0);
  My_LCD.print(t);
  My_LCD.setCursor(5, 1);
  My_LCD.print(h);
  delay(1000); // this speeds up the simulation
}