#include<WiFi.h>
#include<ThingSpeak.h>
char ssid[]="Wokwi-GUEST";
char pass[]="";
unsigned long myChannelNumber=2067971;
const char * myWriteAPIKey="CYG0TXM0NS4UD91X";
int ledPin = 13; // choose the pin for the LED
int inputPin = 2; // choose the input pin (for PIR sensor)
int pirState = LOW; // we start, assuming no motion detected
int val = 0; // variable for reading the pin status
int counter = 0;
int currentState = 0;
int previousState = 0;
void setup() {
pinMode(ledPin, OUTPUT); // declare LED as output
pinMode(inputPin, INPUT); // declare sensor as input
Serial.begin(9600);
}
void loop(){
val = digitalRead(inputPin); // read input value
if (val == HIGH) { // check if the input is HIGH
digitalWrite(ledPin, HIGH); // turn LED ON
if (pirState == LOW) {
  Serial.println("Motion Detected");
// we have just turned on
currentState = 1;
// We only want to print on the output change, not state
pirState = HIGH;
delay(1000);
}
} else {
digitalWrite(ledPin, LOW); // turn LED OFF
if (pirState == HIGH){
  Serial.println("Motion Ended");
// we have just turned of
currentState = 0;
// We only want to print on the output change, not state
pirState = LOW;
}
}
if(currentState != previousState){
if(currentState == 1){
counter = counter + 1;
Serial.println(counter);
}
}
}