/*
   2 sensors  tester
*/

int ledPin = 13; 
int ledPin_br=12;                // choose the pin for the LED
int inputPin = 2;  
int inputPin_ldr=4;             // choose the input pin (for PIR sensor)
int pirState = LOW; 
int ldrState =LOW;            // we start, assuming no motion detected
int val = 0; 
int val1 =99;                 // variable for reading the pin status

void setup() {
  pinMode(ledPin, OUTPUT); 
  pinMode(ledPin_br, OUTPUT);     // declare LED as output
  pinMode(inputPin, INPUT);  
  pinMode(inputPin_ldr, INPUT);   // declare sensor as input
   
  Serial.begin(9600);
}

void loop() {
//PIR Sensor 
  val = digitalRead(inputPin);  // read input value
  if (val == HIGH) {            // check if the input is HIGH
    digitalWrite(ledPin, HIGH);  // turn LED ON
    if (pirState == LOW) {
      // we have just turned on
      Serial.println("Motion detected!");
      // We only want to print on the output change, not state
      pirState = HIGH;
    }
  } else {
    digitalWrite(ledPin, LOW); // turn LED OFF
    if (pirState == HIGH) {
      // we have just turned of
      Serial.println("Motion ended!");
      // We only want to print on the output change, not state
      pirState = LOW;
    }
  }
//LDR SENSOR SETUP
  val1 = digitalRead(inputPin_ldr);  // read input value
  if (val1 == HIGH) {            // check if the input is HIGH
    digitalWrite(ledPin_br, HIGH);  // turn LED ON
    if (ldrState == LOW) {
      // we have just turned on
      Serial.println("bed Room is dark so Light ON ");
      // We only want to print on the output change, not state
      ldrState = HIGH;
    }
  } else {
    digitalWrite(ledPin_br, LOW); // turn LED OFF
    if (ldrState == HIGH) {
      // we have just turned of
      Serial.println("bed Room isn't dark so Light OFF");
      // We only want to print on the output change, not state
      ldrState = LOW;
    }
  }

}