// Stepper motor on Wokwi!

#include <Stepper.h>
 int arttir=2 ;
 int reset=4 ;
 int durdur=7; //
const int stepsPerRevolution = 200;  // change this to fit the number of steps per revolution
// for your motor

// initialize the stepper library on pins 8 through 11:
Stepper myStepper(stepsPerRevolution, 8, 9, 10, 11);

void setup() {
  // set the speed at 60 rpm:
  myStepper.setSpeed(10);
  // initialize the serial port:
  Serial.begin(9600);
}

void loop() {
 
  if(digitalRead(2)==HIGH){
   
    Serial.println("clockwise");
    myStepper.step(stepsPerRevolution);
    delay(500);
    
  }
  if(digitalRead(4)==HIGH){
   if(stepsPerRevolution > 0){
     stepsPerRevolution==0 ;
   }
  }
  if(digitalRead(7)==HIGH){
   
     Serial.println("counterclockwise");
 myStepper.step(-stepsPerRevolution);
  delay(500);

   
 
  }
  

  
}