#define LED_PIN LED_BUILTIN // ESP32 pin GIOP2 connected to LED

int brightness = 0;  // how bright the LED is
int fadeAmount = 5;  // how many points to fade the LED by

// the setup routine runs once when you press reset:
void setup() {
  Serial.begin(115200);
  delay(150);
  // declare pin GIOP18 to be an output:
  pinMode(LED_PIN, OUTPUT);
}

// the loop routine runs over and over again forever:
void loop() {
  // set the brightness of pin GIOP18:
  analogWrite(LED_PIN, brightness);

  // change the brightness for next time through the loop:
  brightness = brightness + fadeAmount;
  delay(500);
  Serial.print("brightness=");
  Serial.println(brightness);

  // reverse the direction of the fading at the ends of the fade:
  if (brightness <= 0 || brightness >= 255) {
    fadeAmount = -fadeAmount;
    delay(500);
  Serial.print("fadeAmount=");
  Serial.println(fadeAmount);
  }
  // wait for 30 milliseconds to see the dimming effect
  delay(30);
}