//! Blinks an LED
//!
//! This assumes that a LED is connected to the pin assigned to `led`. (GPIO4)

#![no_std]
#![no_main]

use hal::{
    clock::ClockControl, gpio::IO, peripherals::Peripherals, prelude::*, timer::TimerGroup, Delay,
    Rtc,
};
use esp_backtrace as _;
use esp_println::println;

#[entry]
fn main() -> ! {
    let peripherals = Peripherals::take();
    let mut system = peripherals.DPORT.split();
    let clocks = ClockControl::boot_defaults(system.clock_control).freeze();

    // Disable the RTC and TIMG watchdog timers
    let mut rtc = Rtc::new(peripherals.RTC_CNTL);
    let timer_group0 = TimerGroup::new(peripherals.TIMG0, &clocks);
    let mut wdt0 = timer_group0.wdt;
    let timer_group1 = TimerGroup::new(peripherals.TIMG1, &clocks);
    let mut wdt1 = timer_group1.wdt;
    rtc.rwdt.disable();
    wdt0.disable();
    wdt1.disable();
    println!("Hello world!");

    // Set GPIO4 as an output, and set its state high initially.
    let io = IO::new(peripherals.GPIO, peripherals.IO_MUX);
    let mut led = io.pins.gpio4.into_push_pull_output();

    led.set_high().unwrap();

    // Initialize the Delay peripheral, and use it to toggle the LED state in a
    // loop.
    let mut delay = Delay::new(&clocks);

    loop {
        led.toggle().unwrap();
        delay.delay_ms(500u32);
    }
}