#include <Servo.h>
#include <ezButton.h>

Servo myservo;  // create servo object to control a servo
// twelve servo objects can be created on most boards

int pos = 0;    // variable to store the servo position
#define BUTTON_PIN 7
int lastState = HIGH;
int flag=0;
ezButton button(7);


void setup() {
  myservo.attach(9);  // attaches the servo on pin 9 to the servo object
  Serial.begin(115200);
  button.setDebounceTime(50);
  

}

void loop() {

 button.loop(); // MUST call the loop() function first

  if(button.isPressed()) {
    Serial.println("The button is pressed");
    flag=1; 
  }
  

 





     
    
  

if(flag==1) {
  for (pos = 0; pos <= 180; pos += 1) { // goes from 0 degrees to 180 degrees
    // in steps of 1 degree
    myservo.write(pos);              // tell servo to go to position in variable 'pos'
    delay(15);                       // waits 15ms for the servo to reach the position
  }
  flag =0;
}
}
/*
  for (pos = 180; pos >= 0; pos -= 1) { // goes from 180 degrees to 0 degrees
    myservo.write(pos);              // tell servo to go to position in variable 'pos'
    delay(15);                       // waits 15ms for the servo to reach the position
  }
}
*/