const char yes1[] PROGMEM =  "   WITHOUT A DOUBT";
const char yes2[] PROGMEM =  "   YOU MAY RELY ON IT";
const char yes3[] PROGMEM =  "   YES DEFINITELY";
const char yes4[] PROGMEM =  "   SIGNS POINT TO YES";
const char yes5[] PROGMEM =  "   IT IS DECIDEDLY SO";
const char yes6[] PROGMEM =  "   AS I SEE IT - YES";
const char yes7[] PROGMEM =  "   YES";
const char yes8[] PROGMEM =  "   MOST LIKELY";
const char yes9[] PROGMEM =  "   IT IS CERTAIN";
const char yes10[] PROGMEM = "   OUTLOOK GOOD";
const char no1[] PROGMEM =   "   MY SOURCES SAY NO";
const char no2[] PROGMEM =   "   DONT COUNT ON IT";
const char no3[] PROGMEM =   "   VERY DOUBTFUL";
const char no4[] PROGMEM =   "   OUTLOOK NOT SO GOOD";
const char no5[] PROGMEM =   "   MY REPLY IS NO";
const char idk0[] PROGMEM =  "   BETTER NOT TELL YOU NOW";
const char idk1[] PROGMEM =  "   ASK AGAIN LATER";
const char idk2[] PROGMEM =  "   REPLY HAZY TRY AGAIN";
const char idk3[] PROGMEM =  "   CANNOT PREDICT NOW";
const char idk4[] PROGMEM =  "   CONCENTRATE AND ASK AGAIN";

char phrase[36]; //      -->|"                                    "|<--

const char* const theAnswers[] PROGMEM = { yes1, yes2, yes3, yes4, yes5, yes6, yes7, yes8, yes9, yes10,
                                           no1, no2, no3, no4, no5, idk0, idk1, idk2, idk3, idk4,
                                         };


void setup() {
  // put your setup code here, to run once:
  Serial.begin(115200);
  Serial.println("Hello, ESP32-S2!");

  for (uint8_t i = 0; i < 5; i++)
    {
      Serial.print("text:");
      Serial.print(theAnswers[i]);
      Serial.print("\nSize:");
      Serial.println( pgm_read_byte_far(&theAnswers[i][0])) ;
    }
}

void loop() {
  // put your main code here, to run repeatedly:
  delay(10); // this speeds up the simulation
}