#include <Arduino.h>
#include <EEPROM.h>

struct dataSetting
{
  int speed;
  byte stopIndex;
  unsigned int calibration_value[8];
  char name[15];
};

dataSetting setting;

struct IndexData
{
    // ukuran data:
    byte sensorBitValue[2];
    byte modeSensor;
    int L;
    int R;
    int D;
    byte SA;
    long TA;
};

IndexData index;
int address=0;
byte value;

void setup() {
  // put your setup code here, to run once:
  Serial.begin(115200);

  pinMode(6,OUTPUT);

  // EEPROM.write(address,index);
}

void loop() {
  // put your main code here, to run repeatedly:
  // Serial.println(sizeof(float));
  // Serial.println(sizeof(boolean));
  // Serial.println(sizeof(int));
  // Serial.println(sizeof(int[10]));
  // Serial.println(sizeof(setting));
  // Serial.println(sizeof(index));

  // Serial.println(EEPROM.length());
  // Serial.println(0b10100000 + 0b00000001,BIN);

  // read a byte from the current address of the EEPROM
  
  // value = EEPROM.read(address);

  // Serial.print(address);
  // Serial.print("\t");
  // Serial.print(value, BIN);
  // Serial.println();
  analogWrite(6,analogRead(A0)/4);
  Serial.println(analogRead(A0));

  
  delay(1000);
}