//scobar
#include <dht.h>
#define dataPin 8 // Defines pin number to which the sensor is connected
#define ledm 9
#define ledh 10
dht DHT; // Creats a DHT object

void setup() 
{
	Serial.begin(9600);
	pinMode(ledm, OUTPUT);
	pinMode(ledh, OUTPUT);
}
void loop() 
{
	//Uncomment whatever type you're using!
	int readData = DHT.read22(dataPin); // DHT22/AM2302
	//int readData = DHT.read11(dataPin); // DHT11

	float t = DHT.temperature; // Gets the values of the temperature
	float h = DHT.humidity; // Gets the values of the humidity

	// Printing the results on the serial monitor
	Serial.print("Temperature = ");
	Serial.print(t);
	Serial.print(" ");
	Serial.print((char)176);//shows degrees character
	Serial.print("C | ");
	Serial.print((t * 9.0) / 5.0 + 32.0);//print the temperature in Fahrenheit
	Serial.print(" ");
	Serial.print((char)176);//shows degrees character
	Serial.println("F ");
	Serial.print("Humidity = ");
	Serial.print(h);
	Serial.println(" % ");
	Serial.println("");

	if(t>40){
		digitalWrite(ledm, HIGH);
		digitalWrite(ledh, LOW);
	}else{
		digitalWrite(ledh, HIGH);
		digitalWrite(ledm, LOW);
	}

	delay(2000); // Delays 2 secods
}