#include <OneWire.h>

#include <DallasTemperature.h>

// Define to which pin of the Arduino the 1-Wire bus is connected:

#define ONE_WIRE_BUS 2

// Create a new instance of the oneWire class to communicate with any OneWire device:

OneWire oneWire(ONE_WIRE_BUS);

// Pass the oneWire reference to DallasTemperature library:

DallasTemperature sensors(&oneWire);

void setup() {

// Begin serial communication at a baud rate of 9600:

Serial.begin(9600);

// Start up the library:

sensors.begin();

pinMode(10, OUTPUT);

pinMode(7, OUTPUT);

}

void loop() {

// Send the command for all devices on the bus to perform a temperature conversion:

sensors.requestTemperatures();

// Fetch the temperature in degrees Celsius for device index:

float tempC = sensors.getTempCByIndex(0); // the index 0 refers to the first device

// Fetch the temperature in degrees Fahrenheit for device index:

float tempF = sensors.getTempFByIndex(0);

// Print the temperature in Celsius in the Serial Monitor:

Serial.print("Temperature: ");

Serial.print(tempC);

Serial.print(" \xC2\xB0"); // shows degree symbol

Serial.print("C | ");

if (tempC >= 35) {
  Serial.print("Temperatura Alta ");
  digitalWrite(10, HIGH);
}

else {
  Serial.print("Temperatura Baja ");
  digitalWrite(7, HIGH);
}

// Print the temperature in Fahrenheit

Serial.print(tempF);

Serial.print(" \xC2\xB0"); // shows degree symbol

Serial.println("F");

// Wait 1 second:

delay(1000);

}