#include <Servo.h>

Servo myservo;  // create servo object to control a servo

// sensor stuff
const int trigPin = 4;
const int echoPin = 3;

// defines variables
long duration;
int distance;

void setup() {
  myservo.attach(10,600,2300);  // (pin, min, max)
  
  pinMode(trigPin, OUTPUT); // Sets the trigPin as an Output
  pinMode(echoPin, INPUT); // Sets the echoPin as an Input
  Serial.begin(9600); // Starts the serial communication
}

void loop() {
   // Clears the trigPin
  digitalWrite(trigPin, LOW);
  delayMicroseconds(2);
  // Sets the trigPin on HIGH state for 10 micro seconds
  digitalWrite(trigPin, HIGH);
  delayMicroseconds(10);
  digitalWrite(trigPin, LOW);
  // Reads the echoPin, returns the sound wave travel time in microseconds
  duration = pulseIn(echoPin, HIGH);
  // Calculating the distance
  distance = duration * 0.034 / 2;
  // Prints the distance on the Serial Monitor
  Serial.print("Distance: ");
  Serial.println(distance);

  myservo.write(0);  // tell servo to go to a particular angle
  delay(1000);
  
  myservo.write(90);              
  delay(500); 
  
  myservo.write(135);              
  delay(500);
  
  myservo.write(180);              
  delay(1500);                     

}