//---------------------------------------------------------//
//-----------------------Basic Alarm-----------------------//
//---------------------------------------------------------//
//Bryter er simulert detektor
//Hvit knapp er reset av alarm
//
//
//Detektor 1 = sløyfe 1 = pin 12
//Com = pin 13
//
const int Detektor1 = 12;
const int COM = 13;
const int Hvite = 5;
const int RedL = 2;
const int Green_led =3;
const int Buzzer = 4;
int BryterVerdi;
int BryterVerdi2;

void setup() {
 pinMode(Detektor1, OUTPUT);
 pinMode(COM, INPUT_PULLUP);

 pinMode(Green_led, OUTPUT);
 digitalWrite(Green_led, INPUT_PULLUP);
 pinMode(Hvite, INPUT_PULLUP);
 pinMode(RedL, OUTPUT);
 pinMode(Buzzer, OUTPUT);
}
void loop() {

  // Linje:28 sender konstat signal ut Detektor 1
BryterVerdi = digitalRead(COM);
if (BryterVerdi ==  LOW){

  digitalWrite(RedL, HIGH);
  digitalWrite(Green_led, LOW);
  
  digitalWrite(Buzzer, HIGH);
}
else{
  digitalWrite(Buzzer, LOW);  
   }

BryterVerdi2 = digitalRead(Hvite);
if (BryterVerdi2 == LOW){
  digitalWrite(RedL, LOW);
  digitalWrite(Green_led, HIGH);
   }
}

//Laget av Anan Panich
//09.10.2023