#define BLYNK_TEMPLATE_ID "TMPL6nVxofH_a"
#define BLYNK_TEMPLATE_NAME "SENSOR LDR"
#define BLYNK_AUTH_TOKEN "xvcK8jzDFgmPU9Fl9Coe1B4Y69yf_g7b"

#include <BlynkSimpleEsp32.h>

BlynkTimer timer;
char auth[] = BLYNK_AUTH_TOKEN;
char ssid[] = "Wokwi-GUEST";
char pass[] = "";
#define LDRanalog 32
#define pinLED 27
BLYNK_WRITE(V0)
{
  int saklar=param.asInt();
  digitalWrite(pinLED, saklar);
}
BLYNK_CONNECTED() { 
  Blynk.syncAll();
}
//******LDR, pin yg dipakai*********************************************


//******LDR, pengukuran lux*********************************************
const float GAMMA = 0.7;
const float RL10 = 50;


void sendSensor()
{
  //*****LDR, pembacaan analog dan digital***********************
  int nilaiADC = analogRead(LDRanalog);
  

  //*****LDR, menghitungR V, , LUX (hanya jika menggunakan A0****
  float voltage = nilaiADC * 5/4095.0;
  float resistance = 2000 * voltage / (1 - voltage / 5);
  float lux = pow(RL10 * 1e3 * pow(10, GAMMA) / resistance, (1 / GAMMA));
  
  
   //*****SERIAL MONITOR, menampilkan digital, ADC, lux, voltage**
 Serial.print("Nilai ADC     = ");
  Serial.println(nilaiADC);
  Serial.print("Lux           = ");
  Serial.println(lux);
  Serial.print("Tegangan      = ");
  Serial.println(voltage);
  
  delay(500);

   Blynk.virtualWrite(V1, lux);

}

void setup() {
  //*****SERIAL MONITOR, setting baud rate*******************
  Serial.begin(115200);

  //*****ULTRASONIK, setting pin yang digunakan**************

  pinMode(LDRanalog, OUTPUT);
    pinMode(pinLED, OUTPUT);
Blynk.begin(auth, ssid, pass);
 timer.setInterval(1000L, sendSensor);
}

void loop() {
  //********BLYNK, menjalankan blynk****************************
  Blynk.run();
  timer.run();
}