#define BLYNK_TEMPLATE_ID "TMPL6B3w1QhVu"
#define BLYNK_TEMPLATE_NAME "kandang pitik"
#define BLYNK_AUTH_TOKEN "lHhm--wMod7U7Vuvv7LyoQOk193g9sVk"


//**********BLYNK, library**************************************
#include <BlynkSimpleEsp32.h>
#include <Wire.h>
#include <Adafruit_GFX.h>
#include <Adafruit_SSD1306.h>
//define lebar dan tinggi oled
#define lebarOLED 128
#define tinggiOLED 64 

Adafruit_SSD1306 OLED(lebarOLED, tinggiOLED, &Wire, -1);
BlynkTimer timer;

//*********DHT22, library****************************************
#include "DHTesp.h"

//**********BLYNK, ssid, pass, token****************************
char auth[] = BLYNK_AUTH_TOKEN;
char ssid[] = "Wokwi-GUEST";
char pass[] = "";

//*********DHT22, deklarasi pin**********************************
const int DHT_PIN = 15;
DHTesp dhtSensor;
float suhu;
float kelembapan;

//*****BLYNK, kirim nilai sensor*****************************
void sendSensor()
{
    //*********DHT22, membaca suhu dan kelembaban******************
  TempAndHumidity  data = dhtSensor.getTempAndHumidity();
  suhu=data.temperature;
  kelembapan=data.humidity;

  //*****SERIAL MONITOR, menampilkan data suhu dan kelembaban****
   OLED.clearDisplay();
  OLED.setCursor(0,0);
  OLED.print("Suhu      : ");
  OLED.print(suhu);
  OLED.setCursor(0,10);
  OLED.print("Kelembapan: ");
  OLED.print(kelembapan);
  OLED.display();

  
  //*****BLYNK, kirim nilai sensor*****************************
  Blynk.virtualWrite(V0, suhu);
  Blynk.virtualWrite(V3, kelembapan);
}

//******blink lampu**(*(**))

BLYNK_WRITE(V1) // Menangani perintah dari tombol Blynk
{
int pinValue = param.asInt();
 if (pinValue == 1) {
// Lampu dihidupkan
digitalWrite(2 , HIGH);
} else {
   // Lampu dimatikan
digitalWrite(2 , LOW);
  }

}


void setup() {
  Serial.begin(115200);
  if (!OLED.begin(SSD1306_SWITCHCAPVCC, 0x3C))
  {
    Serial.print(F("Gagal menghubungkan OLED"));
    while(1);
  }
  delay(2000);

  OLED.clearDisplay();
  OLED.setTextSize(1);
  OLED.setTextColor(WHITE);
   //********BLYNK, mulai koneksi ke blynk***********************
  Blynk.begin(auth, ssid, pass);
  timer.setInterval(1000L, sendSensor);
  
  //*****SERIAL MONITOR, setting baud rate***********************
  Serial.begin(115200);

  //*****DHT 22, setting*****************************************
  dhtSensor.setup(DHT_PIN, DHTesp::DHT22);
}

void loop() {
 //********BLYNK, menjalankan blynk****************************
  Blynk.run();
  timer.run();
}