#define  ECHO_PIN 3
#define  TRIG_PIN 2
#define  pinBuzzer 5
#define  pinLampuHijau 6
#define  pinLampuMerah 7

#include <Servo.h>

Servo myservo;
int rotasi = 90;
int interval = 0;

float readDistanceCM(){
  digitalWrite(TRIG_PIN, LOW);
  delayMicroseconds(2);
  digitalWrite(TRIG_PIN, HIGH);
  delayMicroseconds(10);
  digitalWrite(TRIG_PIN, LOW);
  int duration = pulseIn(ECHO_PIN, HIGH);
  return duration * 0.034/2;
}

void soundBuzzer(){
  if(interval < 500){
    tone(pinBuzzer, 250);
  } else if(interval > 500){
    tone(pinBuzzer, 100,800);
  }
}

void setLampuHijau(int status) {
  digitalWrite(pinLampuHijau, status);
}

void setLampuMerah(int status) {
  digitalWrite(pinLampuMerah, status);
}

void setup() {
  // put your setup code here, to run once:
  pinMode(TRIG_PIN, OUTPUT);
  pinMode(ECHO_PIN, INPUT);
  pinMode(pinBuzzer, OUTPUT);
  pinMode(pinLampuHijau, OUTPUT);
  pinMode(pinLampuMerah, OUTPUT);
  myservo.attach(9);
  myservo.write(90);
  setLampuMerah(LOW); 
  setLampuHijau(LOW); 
  Serial.begin(115200);
}

void loop() {

  tutupPalang();
  interval += 100;
  if(interval > 1000) interval = 0;
}

void tutupPalang(){
  float jarak = readDistanceCM();
  if(jarak > 0 && jarak < 100 ){
    soundBuzzer();
    tutup();
    setLampuMerah(HIGH); 
    setLampuHijau(LOW); 
  } else {
    buka();
    noTone(pinBuzzer);
    setLampuMerah(LOW); 
    setLampuHijau(HIGH); 
  }
}

// Palang
void buka(){
  if(rotasi > 0){
    myservo.write(rotasi);
    delay(100);
    rotasi--;
  }
  if(rotasi <= 0 ) rotasi = 0;
}

void tutup(){
  if(rotasi < 90){
    myservo.write(rotasi);
    delay(100);
    rotasi+=4;
  }
  if(rotasi >= 90 ) rotasi = 90;
}