#define BLYNK_TEMPLATE_ID "TMPL6WahqTCB9"
#define BLYNK_TEMPLATE_NAME "Finpro"
#define BLYNK_AUTH_TOKEN "nmuZ0JIQwhtE0D0g3A1GzBXCvvemw-Qi"

#include "DHT.h"
#include <BlynkSimpleEsp32.h>
#define DHT22_PIN 13
#define DHTTYPE DHT22
DHT dht (DHT22_PIN, DHTTYPE);

char auth[] = BLYNK_AUTH_TOKEN;
char ssid[] = "Wokwi-GUEST";
char pass[] = "";

BlynkTimer timer;

void setup() {
  Serial.begin(115200);
  Serial.println("STARTING");
  dht.begin();

}

void loop() {
  Blynk.begin(auth, ssid, pass);
  //timer.setInterval(2000, sendDHTData); // Send DHT data every 2 seconds  
  // Reading temperature or humidity takes about 250 milliseconds!
  // Sensor readings may also be up to 2 seconds 'old' (its a very slow sensor)
  float h = dht.readHumidity();
  // Read temperature as Celsius (the default)
  float t = dht.readTemperature();

  // Check if any reads failed and exit early (to try again).
  if (isnan(h) || isnan(t)) {
    Serial.println(F("Failed to read from DHT sensor!"));
    return;
  }
  Blynk.virtualWrite(V0, t);
  Blynk.virtualWrite(V1, h);
   
  Serial.print(F("Humidity: "));
  Serial.print(h);
  Serial.print(F("%  Temperature: "));
  Serial.print(t);
  Serial.println(F("°C "));
  Serial.println("---");
 // Wait a few seconds between measurements.
  delay(1000);

}