void setup(){

  #include <DHT.h> // include adafruit library unified sensor
  #define DHTPIN 2 // Set DHT pin:

  #define DHTTYPE DHT22 // Set DHT type, DHT 22 

  DHT dht = DHT(DHTPIN, DHTTYPE); // Initialize DHT sensor for normal 16mhz Arduino:

  Serial.begin(9600): // Begin serial communication at a band rate of 9600:

  dht.begin(); // Setup sensor:

}
void loop(){
  
    delay(2000); // Wait a 2 seconds between measurements:
  // Reading temperature or humidity takes about 250 milliseconds!
  // Sensor readings may also be up to 2 seconds 'old' 

  float h = dht.readHumidity(); //Read the humidity in %:
  float t = dht.readTemperature(); // Read the temperature as Celsius:

  Serial.print("Humidity: "); // Serial monitor to display the word “Humidity”
  
  Serial.print(h); // Serial monitor to display the value of humidity in the sensor
  Serial.print(" % "); // Serial monitor to display “%”

  Serial.print("Temperature: "); // Serial monitor to display the word “Temperature”

  Serial.print(t); // Serial monitor to display the value of temperature in the sensor
  
  Serial.print(" \xC2\xB0");	
  
  Serial.println("C | "); // Serial monitor in line format to display the word “C I”}