#include <IRremote.h>


#define PIN_RECEIVER 2   // Signal Pin of IR receiver

int redLed = 5;
int yellowLed = 4;
int greenLed = 3;
int blueLed = 6;

IRrecv receiver(PIN_RECEIVER);
void setup()
{
  Serial.begin(9600);
  Serial.println("<press a button>");
  receiver.enableIRIn(); // Start the receiver

pinMode(redLed, OUTPUT);
pinMode(yellowLed, OUTPUT);
pinMode(greenLed, OUTPUT);
pinMode(blueLed, OUTPUT);

}
void loop()
{
  // Checks received an IR signal
  if (receiver.decode()) {
    translateIR();
    receiver.resume();  // Receive the next value
  }
}
void translateIR()
{
  // Takes command based on IR code received
  switch (receiver.decodedIRData.command) {
    case 162:
      Serial.println("POWER");
      digitalWrite(redLed, HIGH);
      delay(500);
      digitalWrite(redLed, LOW);
      break;
    case 226:
      Serial.println("MENU");
      digitalWrite(blueLed, HIGH);
      delay(500);
      digitalWrite(blueLed, LOW);
      break;
    case 34:
      Serial.println("TEST");
      break;
    case 2:
      Serial.println("PLUS");
      break;
    case 194:
      Serial.println("BACK");
      break;
    case 224:
      Serial.println("PREV.");
      break;
    case 168:
      Serial.println("PLAY");
      break;
    case 144:
      Serial.println("NEXT");
      break;
    case 104:
      Serial.println("num: 0");
      break;
    case 152:
      Serial.println("MINUS");
      break;
    case 176:
      Serial.println("key: C");
      break;
    case 48:
      Serial.println("num: 1");
      break;
    case 24:
      Serial.println("num: 2");
      break;
    case 122:
      Serial.println("num: 3");
      break;
    case 16:
      Serial.println("num: 4");
      break;
    case 56:
      Serial.println("num: 5");
      break;
    case 90:
      Serial.println("num: 6");
      break;
    case 66:
      Serial.println("num: 7");
      break;
    case 74:
      Serial.println("num: 8");
      break;
   default:
      Serial.println("num: 9");
      
    
      
     // Serial.println(receiver.decodedIRData.command);
      //Serial.println(" other button");
  }
}