// ESP-01

/*
  AT Firmware simulation example

  Use the serial monitor to interface with the AT firmware. For instance, to scan for WiFi:

AT+CWMODE=1
AT+CWLAP

  Connect to WiFi:

AT+CWJAP="Wokwi-GUEST",

  Show the current IP address:

AT+CIFSR

  Show firmware version

AT+GMR

  To show list list of available commands:

AT+CMD?

*/

*/
pinout

  GND        GPIO2    GPIO0   RX/GPIO1
  TX/GPIO3   Enable   Reset   3.3V VCC

*/

void setup() {
  // put your setup code here, to run once:

}

void loop() {
  // put your main code here, to run repeatedly:

}