#include <IRremote.h>
#include <FastLED.h>
#include <Servo.h>

CRGB leds[0];
int pin_receiver = 2;
int button_value = 0;
int bright = 20;

Servo myservo1;
IRrecv receiver(pin_receiver);


void setup() {
  // put your setup code here, to run once:
  receiver.enableIRIn();
  myservo1.attach(9);
  Serial.begin(9600);
  FastLED.addLeds<NEOPIXEL, 3>(leds,1);

}

void loop() {
  // put your main code here, to run repeatedly:
  if(receiver.decode()){
    translateIR();
    receiver.resume();
  }

}

void translateIR(){
  button_value = receiver.decodedIRData.command;

  if(button_value == 226){
    Serial.println("Forward - Driver door opens, Backward - Driver door closes, 1 - Light on in red, 2 - Lights on in GREEN, 3 - lights on in BLUE, 4 - Blinking LED, Play - Control LED glow, Power - All Stop");

  }

  if(button_value == 224){
    myservo1.write(0);
    Serial.println("Door Closed");
  }

  if(button_value == 144){
    myservo1.write(180);
    Serial.println("Door Open");
  }

  if(button_value == 48){
    leds[1] = CRGB::Red;
    FastLED.show();
  }

  if(button_value == 24){
    leds[1] = CRGB::Green;
    FastLED.show();
  }

  if(button_value = 122){
    leds[1] = CRGB::Blue;
    FastLED.show();
  }

  if(button_value == 16){
    for(int i = 0; i<=20; i++){
      leds[1] = CRGB::Cyan;
      FastLED.show();
      delay(50);

      leds[1] = CRGB::Yellow;
      FastLED.show();
      delay(50);

      leds[1] = CRGB::Pink;
      FastLED.show();
      delay(50);
    }
  }

  if(button_value == 168){
    bright = bright + 40;
    FastLED.setBrightness(bright);
    FastLED.show();
  }

  if(button_value == 162){
    Serial.println("Application Stopped");
    myservo1.write(90);
    FastLED.clear();
    FastLED.show();
  }
}