#include <LiquidCrystal.h>
#include <OneWire.h>
#include <DallasTemperature.h>
LiquidCrystal lcd (A0,A1,A2,A3,A4,A5);
#define ONE_WIRE_BUS 5
OneWire oneWire(ONE_WIRE_BUS);

DallasTemperature sensors(&oneWire);

DeviceAddress Sensor;

void setup() {
  // put your setup code here, to run once:
Serial.begin(9600);
  lcd.begin(20,2);
  lcd.print("Monitoring Suhu Air");
pinMode(6, OUTPUT);
pinMode(7, OUTPUT);
 Serial.println("Monitoring Suhu Air ");
 delay(2000);
 lcd.clear();
  sensors.begin();
  Serial.println("Aktif");
  Serial.print(sensors.getDeviceCount(), DEC);


   if (!sensors.getAddress(Sensor, 0))
   sensors.setResolution(Sensor, 9);
     sensors.requestTemperatures();
float suhu = sensors.getTempC(Sensor);
Serial.println(suhu);
  lcd.setCursor(0,0);
  lcd.print("SUHU =" );
  lcd.print(suhu);
}

void loop() {
  // put your main code here, to run repeatedly:
 Serial.println("Nilai Suhu =");
  sensors.requestTemperatures();
float suhu = sensors.getTempC(Sensor);
Serial.println(suhu);
  lcd.setCursor(0,0);
  lcd.print("SUHU =" );
  lcd.print(suhu);
if (suhu>96){
  digitalWrite(6, LOW);
  digitalWrite(7, LOW);
  Serial.println("Suhu Diatas 95 C");
  lcd.setCursor(0,1);
  lcd.print("Suhu Diatas 95C     ");
  lcd.print("BOILER OFF");
}
if(suhu<85){
  digitalWrite(6, HIGH);
  digitalWrite(7, LOW);
  Serial.println("Suhu Dibawah 85 C");
  lcd.setCursor(0,1);
  lcd.print("Suhu Dibawah 85C    ");
  lcd.print("BOILER ON ");
}
if ((suhu>85)&&(suhu<95)){
  digitalWrite(6, LOW);
  digitalWrite(7, HIGH);
  Serial.println("Suhu Masih Dalam Kondisi Stabil");
  lcd.setCursor(0,1);
  lcd.print("Suhu Stabil         ");
  lcd.print("BOILER ON ");
}
delay(2000);
}