//#include "driver/can.h"

struct __attribute__((__packed__)) SetBaudRate {
  std::uint8_t command_byte = 0xB4;
  uint8_t : 8;
  uint8_t : 8;
  uint8_t : 8;
  uint8_t : 8;
  uint8_t : 8;
  uint8_t : 8;
  std::uint8_t baud_rate;
};

void setup() {
  // put your setup code here, to run once:
  Serial.begin(115200);
  Serial.println("Hello, ESP32-C3!");
}

void loop() {
  SetBaudRate s;
  s.baud_rate = 0x01;
  //Serial.println(s.command_byte);
  Serial.println(sizeof(SetBaudRate));
  /*can_message_t message;
  message.identifier = 0xAAAA;
  message.flags = CAN_MSG_FLAG_EXTD;
  message.data_length_code = 8;
  message.data[i] = 0;*/
  delay(10); // this speeds up the simulation
}