#include <EEPROM.h>
#include <LiquidCrystal.h>

LiquidCrystal lcd(2, 3, 4, 5, 6, 7);

long duration, inches;
int set_val, percentage;
bool state, pump;

void setup() {
  lcd.begin(16, 2);
  lcd.print("WATER LEVEL:");
  lcd.setCursor(0, 1);
  lcd.print("PUMP:OFF MANUAL");

  pinMode(8, OUTPUT);
  pinMode(9, INPUT);
  pinMode(10, INPUT_PULLUP);
  pinMode(11, INPUT_PULLUP);
  pinMode(12, OUTPUT);

  set_val = EEPROM.read(0);
  if (set_val > 150) set_val = 150;
}

void loop() {
  digitalWrite(3, LOW);
  delayMicroseconds(2);
  digitalWrite(8, HIGH);
  delayMicroseconds(10);
  digitalWrite(8, LOW);
  duration = pulseIn(9, HIGH);
  inches = microsecondsToInches(duration);

  percentage = (set_val - inches) * 100 / set_val;

  lcd.setCursor(12, 0);
  if (percentage < 0) percentage = 0;
  lcd.print(percentage);
  lcd.print("%   ");

  if (!digitalRead(11)) {
    // MANUAL mode
    if (percentage < 30 && digitalRead(10)) {
      pump = 0; // Turn on the pump manually when percentage is < 30 and switch is ON
    } else if (percentage > 90) {
      pump = 0; // Turn off the pump automatically when percentage is > 90
    }
  } else {
    // AUTO mode
    if (percentage < 30) {
      pump = 1; // Turn on the pump when percentage is < 30 in AUTO mode
    } else if (percentage > 90) {
      pump = 0; // Turn off the pump when percentage is > 90 in AUTO mode
    }
  }

  digitalWrite(12, !pump);

  lcd.setCursor(5, 1);
  if (pump == 1)
    lcd.print("ON ");
  else if (pump == 0)
    lcd.print("OFF");

  lcd.setCursor(9, 1);
  if (!digitalRead(11))
    lcd.print("MANUAL");
  else
    lcd.print("AUTO   ");

  if (!digitalRead(10) && !state && digitalRead(11)) {
    state = 1;
    set_val = inches;
    EEPROM.write(0, set_val);
  }

  if (!digitalRead(10) && !state && !digitalRead(11)) {
    state = 1;
    pump = !pump;
  }

  if (digitalRead(10)) state = 0;

  delay(500);
}

long microsecondsToInches(long microseconds) {
  return microseconds / 74 / 2;
}