#include <Arduino.h>
#include <OneWire.h>
#include <DallasTemperature.h>
#include <PID_v1.h>

#define ONE_WIRE_BUS 2
#define LedPIN 3

OneWire oneWire(ONE_WIRE_BUS);
DallasTemperature sensor(&oneWire);

DeviceAddress tempDeviceAddress;

//Define Variables we'll be connecting to
double Setpoint, Input, Output;

int target = 10;

//Specify the links and initial tuning parameters
byte Kp=2, Ki=5, Kd=1;
PID myPID(&Input, &Output, &Setpoint, Kp, Ki, Kd, DIRECT);

int WindowSize = 1000;
unsigned long windowStartTime;



void setup()
{
  Serial.begin(9600);

  pinMode(LedPIN, OUTPUT);
  digitalWrite(LedPIN, LOW);

  sensor.begin();

  windowStartTime = millis();

  //initialize the variables we're linked to
  //Setpoint = 100;
  Setpoint = target;

  //tell the PID to range between 0 and the full window size
  myPID.SetOutputLimits(0, WindowSize);

  //turn the PID on
  myPID.SetMode(AUTOMATIC);
}

void printTemperature(DeviceAddress deviceAddress)
{
 
  float tempC = sensor.getTempC(deviceAddress);
  if (tempC == DEVICE_DISCONNECTED_C)
  {
    Serial.println("Error: Could not read temperature data");
    return;
  }
  Input = tempC;
  //Serial.print("Temp C: ");
  //Serial.print(tempC);
}

void loop()
{
  sensor.requestTemperatures(); // Send the command to get temperatures
 
  sensor.getAddress(tempDeviceAddress, 0);

  // It responds almost immediately. Let's print out the data
  printTemperature(tempDeviceAddress); // Use  

  //Input = analogRead(PIN_INPUT);
  myPID.Compute();

  /************************************************
   * turn the output pin on/off based on pid output
   ************************************************/
  if (millis() - windowStartTime > WindowSize)
  { //time to shift the Relay Window
    windowStartTime += WindowSize;
  }
  if (Output < millis() - windowStartTime) digitalWrite(LedPIN, LOW);
  else digitalWrite(LedPIN, HIGH);
  Serial.println(Output);
}