#include <IRremote.h>
int led_pin = 3;
int pin_receiver = 2;
int button_value = 0;
IRrecv receiver(pin_receiver);

void setup() {
  // put your setup code here, to run once:
  Serial.begin(9600);
  receiver.enableIRIn();
}

void loop() {
  // put your main code here, to run repeatedly:
  if(receiver.decode()){
    translateIR();
    receiver.resume();
    }
}
int translateIR()
{
  button_value = receiver.decodedIRData.command;
  Serial.println(button_value);
  if(button_value == 162){
    Serial.println("Power");
    digitalWrite(led_pin,LOW);
  }
  if(button_value == 226){
    Serial.println("Menu");
    Serial.println("Press test to turn on LED");
    Serial.println("Press POWER to turn off LED");
    Serial.println("Press ONE to blink LED");
  }
  if(button_value == 34){
    Serial.println("Test");
    digitalWrite(led_pin,HIGH);
  }
  if(button_value == 48){
    Serial.println("One");
    digitalWrite(led_pin,HIGH);
    delay(300);
    digitalWrite(led_pin,LOW);
    delay(300);
    digitalWrite(led_pin,HIGH);
    delay(300);
    digitalWrite(led_pin,LOW);
  }
}