// set pin numbers
const int sensorPin = 32;
const int ledRed=27;
const int ledGreen=33;
  // the number of the pushbutton pin
//const int sensorPin = 5;    // the number of the LED pin

// variable for storing the pushbutton status 
int sensorState = 0;

void setup() {
  Serial.begin(115200);  
  // initialize the pushbutton pin as an input
  pinMode(sensorPin, INPUT);
  pinMode(ledRed, OUTPUT);
  pinMode(ledGreen, OUTPUT);
  // initialize the LED pin as an output
  //pinMode(ledPin, OUTPUT);
}

void loop() {
  // read the state of the pushbutton value
  sensorState = digitalRead(sensorPin);
  delay(1000);
  // check if the pushbutton is pressed.
  // if it is, the buttonState is HIGH
  if (sensorState == HIGH) {
    // turn LED on
    digitalWrite(ledRed, HIGH);
    digitalWrite(ledGreen, LOW);
    Serial.println("Dark");
    //digitalWrite(ledPin, HIGH);
  } else {
    // turn LED off
    digitalWrite(ledGreen, HIGH);
    digitalWrite(ledRed, LOW);
    Serial.println("Bright");
    //digitalWrite(ledPin, LOW);
  }
}