// set pin numbers
const int sensorPin = 34;  // the number of the pushbutton pin
const int ledRed = 14;
const int ledGreen = 26;
const int ledBlue = 25;

const float x = 0.0008122077282;

// variable for storing the pushbutton status 
float sensorValue = 0;

void setup() {
  Serial.begin(115200);  
  pinMode(sensorPin, INPUT);
  pinMode(ledRed, OUTPUT);
  pinMode(ledGreen, OUTPUT);
  pinMode(ledBlue, OUTPUT);
  // initialize the LED pin as an output
  // pinMode(ledpin, OUTPUT);
}

void loop() {
  // read the state of the pushbutton value
  sensorValue = analogRead(sensorPin);
  sensorValue *= x;
  delay(500);
  // check if the pushbutton is pressed.
  // if it is, the buttonState is HIGH
  // Serial.print(sensorValue);
  // Serial.println(" Volts");

  if (sensorValue <= 1.10) {
    digitalWrite(ledRed, HIGH);
    digitalWrite(ledGreen, LOW);
    digitalWrite(ledBlue, LOW);
    Serial.println("Low");
  } else if ((sensorValue <= 2.10) && (sensorValue > 1.10)) {
    digitalWrite(ledRed, LOW);
    digitalWrite(ledGreen, LOW);
    digitalWrite(ledBlue, HIGH);
    Serial.println("Moderate");
  } else {
    digitalWrite(ledRed, LOW);
    digitalWrite(ledGreen, HIGH);
    digitalWrite(ledBlue, LOW);
    Serial.println("Bright");
  }

}