// ATtiny85 Blink!

#define SIGNA_PIN PB0
int SIGNAL; 


//Mehr Infos: https://arduino-projekte.webnode.at/meine-projekte/servosteuerung/modellbahnschranke/
 
 void setup(){

 pinMode(PINB0, INPUT);
 pinMode(PINB1, OUTPUT); // Blinking Lights
 pinMode(PINB2, OUTPUT); // Landing Lights
 pinMode(PINB3, OUTPUT); // Constant Lights
 
 }
 void loop(){
(PINB0 ,LOW);




digitalRead(PINB0);
digitalWrite(PINB2, LOW);
digitalWrite(PINB1, LOW);
digitalWrite(PINB3, LOW);
delay(1);
if (PINB0 == HIGH)
{
  digitalWrite(PINB1, HIGH);
  digitalWrite(PINB2, LOW);
  
for (int i = 0; i< 1300; i++) {
if (PINB0 == HIGH) digitalWrite(PINB3, HIGH); else digitalWrite(PINB4, LOW);
delay(1);
}

  digitalWrite(PINB3, HIGH);
  delay(95);
  digitalWrite(PINB3, LOW);
  delay(95);
  digitalWrite(PINB3, HIGH);
  
}
 if (PINB0 == LOW) {
}
{
 digitalWrite(PINB4, LOW);
 digitalWrite(PINB3, LOW);
}
}