/*
   PIR sensor tester
*/

int ledPin = 13;                // choose the pin for the LED
int inputPin = 2;               // choose the input pin (for PIR sensor)
int pirState = LOW;             // we start, assuming no motion detected
int val = 0;                    // variable for reading the pin status
int ledpin = 12;
//pinMode(12, OUTPUT);
void setup() {
  pinMode(ledPin, OUTPUT);      // declare LED as output
  pinMode(inputPin, INPUT);     // declare sensor as input
pinMode(12, OUTPUT);
  Serial.begin(9600);
}

void loop() {
  val = digitalRead(inputPin);  // read input value
  if (val == HIGH) {            // check if the input is HIGH
    digitalWrite(ledPin, HIGH);  // turn LED ON
    //if (pirState == LOW) {
     //digitalWrite( 12, HIGH);
      //if (pirState == LOW);
     digitalWrite( 12, LOW);
      // we have just turned on
      Serial.println("Motion detected!");
      // We only want to print on the output change, not state
      pirState = HIGH;
    }
  
   else {
    digitalWrite(ledPin, LOW); // turn LED OFF
    if (pirState == HIGH) {
      // we have just turned of
      Serial.println("Motion ended!");
      // We only want to print on the output change, not state
      pirState = LOW;
      digitalWrite( 12, HIGH);
     // if (pirState == LOW);
     //digitalWrite( 12, LOW);
    }
  }}