#include <SPI.h>
#include <Wire.h>
#include <Adafruit_GFX.h>
#include <Adafruit_SSD1306.h>

#include <Fonts/FreeSans9pt7b.h>
#include <Fonts/FreeSansBold9pt7b.h>

#define SCREEN_WIDTH    128 // OLED display width, in pixels
#define SCREEN_HEIGHT   32 // OLED display height, in pixels
#define OLED_RESET      -1 // Reset pin # (or -1 if sharing Arduino reset pin)
#define SCREEN_ADDRESS  0x3C ///< See datasheet for Address; 0x3D for 128x64, 0x3C for 128x32


Adafruit_SSD1306 display(SCREEN_WIDTH, SCREEN_HEIGHT, &Wire, OLED_RESET);

void printLocalTime() {
  display.setTextSize(1);
  display.setTextColor(WHITE);
  display.display();
  display.clearDisplay();

  display.setCursor(1, 1);
  display.println("10:12:44");

  display.setCursor(60, 1);
  display.println("12/01/2023");
}


void setup()

{
  Serial.begin (115200);
   while (!Serial)
    {
    }

  Serial.println ();
  Serial.println ("I2C scanner. Scanning ...");
  byte count = 0;
  pinMode(13,OUTPUT); 
  digitalWrite(13,HIGH);
  Wire.begin();
  for (byte i = 1; i < 120; i++)
  {
    Wire.beginTransmission (i);
    if (Wire.endTransmission () == 0)
      {
      Serial.print ("Found address: ");
      Serial.print (i, DEC);
      Serial.print (" (0x");
      Serial.print (i, HEX);
      Serial.println (")");
      count++;
      delay (1); 
      } 
  } 
  Serial.println ("Done.");
  Serial.print ("Found ");
  Serial.print (count, DEC);
  Serial.println (" device(s).");

  display.begin(SSD1306_SWITCHCAPVCC, 0x3C);
  display.clearDisplay();


} 

void loop() {
  printLocalTime(); 
  delay(250);
}