#define BLYNK_TEMPLATE_ID "TMPL6g-z5eTl1"
#define BLYNK_TEMPLATE_NAME "Thobi remed"
#define BLYNK_AUTH_TOKEN "4IJkLxjLkBKN9eHErszdzFsMe9b-aVzC"

#define BLYNK_PRINT Serial

#include<WiFi.h>
#include<WiFiClient.h>
#include<BlynkSimpleEsp32.h>

#include <LiquidCrystal_I2C.h>
LiquidCrystal_I2C lcd(0x27, 16,2);
const int pinPot = 33;
const int pinLED = 27;
int sensor = 0;
int levelsensor=0;
float vin;
int brightness = 0;

void setup() {
 // put your setup code here, to run once:
 pinMode(pinPot, INPUT);
 pinMode(pinLED, OUTPUT);
 Serial.begin(115200);
 lcd.init();
 lcd.backlight();
 lcd.setCursor(0,0);
 lcd.print("Thobi 2204060");
 Serial.println("Hello, ESP32!");
}

void loop() {
 // put your main code here, to run repeatedly:
 sensor = analogRead(pinPot);
 vin=((float)(3.3*sensor))/4095;
 brightness = map(sensor, 2478, 4095, 0, 255);
 levelsensor=map(brightness, 0, 255, 0, 100);
 
 
 lcd.clear();
  lcd.setCursor(0, 0);
  lcd.print("Thobi 2204044 : ");
  lcd.setCursor(5, 1);
  lcd.print(sensor, 1);
  lcd.setCursor(10, 1);
  lcd.print(vin, 1);
  lcd.setCursor(13, 1);
  lcd.print("V");
  lcd.setCursor(0, 1);
  if (levelsensor >= 0 and levelsensor <= 100) {
    lcd.print(levelsensor, 1);
    lcd.setCursor(3, 1);
    lcd.print("%");
  }
 
 analogWrite(pinLED, brightness);
 if (vin<3) {
  Serial.println("EMpty");
 }else{
  Serial.print(levelsensor);
  Serial.println("%");
 }

 Serial.print("Nilai Sensor : ");
 Serial.println(sensor);
 delay(1000); // this speeds up the simulation

 
}