const int ctSensorPin = 25; // Connect the CT sensor output to digital pin 2
const int threshold = 500; // Set your current threshold value (adjust as needed)
const int ledPin = 13; // Connect an LED or use the built-in LED on pin 13

void setup() {
  Serial.begin(9600);
  pinMode(ctSensorPin, INPUT_PULLUP);
  pinMode(ledPin, OUTPUT);
}

void loop() {
  int sensorValue = analogRead(ctSensorPin);
  Serial.println(sensorValue);

  // Check if the current exceeds the threshold
  if (sensorValue > threshold) {
    digitalWrite(ledPin, HIGH); // Turn on the LED or send a digital signal
    delay(1000); // Wait for 1 second (adjust as needed)
    digitalWrite(ledPin, LOW); // Turn off the LED or reset the digital signal
  }

  delay(100); // Adjust the delay as needed for your application
}