/**
   ESP32 + DHT22 Example for Wokwi
   
   https://wokwi.com/arduino/projects/322410731508073042
*/

#include "DHTesp.h"

const int DHT_PIN = 15;
const int Heater = 32;
const int AirConditioning = 33;

DHTesp dhtSensor;

void setup() {
  Serial.begin(115200);
  dhtSensor.setup(DHT_PIN, DHTesp::DHT22);

  pinMode(Heater, OUTPUT);
  pinMode(AirConditioning, OUTPUT);
}

void loop() {
  TempAndHumidity  data = dhtSensor.getTempAndHumidity();
  Serial.println("Temp: " + String(data.temperature, 2) + "°C");
  Serial.println("Humidity: " + String(data.humidity, 1) + "%");
  Serial.println("---");

  if (data.temperature < 20) {
    digitalWrite(Heater, HIGH);
    digitalWrite(AirConditioning, LOW);
    Serial.println ("Temperatur Dingin, Heater ON dan AC OFF");
  }
  if (data.temperature > 20 && data.temperature < 26) {
    digitalWrite(Heater, LOW);
    digitalWrite(AirConditioning, LOW);
    Serial.println ("Temperatur Sesuai,Heater OFF dan AC OFF");

  }
  if (data.temperature > 26) {
    digitalWrite(Heater, LOW);
    digitalWrite(AirConditioning, HIGH);
    Serial.println ("Temperatur Panas, Heater OFF dan AC ON");
  }

  delay(2000); // Wait for a new reading from the sensor (DHT22 has ~0.5Hz sample rate)

}